CopyrightCopyright © PLANET Technology Corp. 2004.Contents subject to revision without prior notice.PLANET is a registered trademark of PLANET
67Chapter 6Installing the ConverterPlease follow these steps to install the converter: • Turn off the power of the device/station in a network to whi
67Chapter 7Duplex Mode settingThe TP port of FT-80X supports duplex mode detection by auto-negotiation (A-N). The following is the duplex mode para
89Chapter 8LED indicationLED Color DescriptionFX LNK / ACTGreen Blinks: when any FX packets transmit-ting and receivingLit: when Fiber connection is g
89Chapter 9Cable Connection ParameterThe limitations are as below:Duplex Connection Limitation (max.)Twisted PairHalf / FullNode to NodeNode to Switch
1011Chapter 10FT-80X Technical SpecificationsThe FT-80X comes with the following standard features: · Standard: IEEE802.3/u, 10/100Base-TX and 100Bas
1011Chapter 11Power informationThe power jack of FT-80X is with 2.5mm in the central post and required +5VDC power input. It will conform to the bundl
12This page is intentionally left blank
12
2010-000002-005
installed and used in accordance with this user’s guide, may cause harmful interference to radio communica-tions. Operation of this equipment in
Table of ContentsChapter 1 Overview 1Chapter 2 Model List 1Chapter 3 Checklist 2Chapter 4 Product Outlook 2Chapter 5 Link Fault Pass through (LFP
1Chapter 1OverviewThank you for purchasing PLANET FT-80X family 10/100Mbps Ethernet Twisted pair to 100Base-FX Fiber-optic Bridge Converter. Th
23Chapter 3ChecklistYour FT-80X carton should contain the following items:ð The Fast Ethernet Bridge Converterð AC-DC Power Adapter (Output: 5VDC, 2
23Side View (FT-80X)One DIP switch for Link Fault Pass Through (LFP) feature, “ON” to turn-on the LLCF and LLR detection. And “OFF” to turn–off this
45Link Loss Carry Forward (LLCF)FT-80X incorporates an LLCF function for troubleshooting a remote connection. When LFP function is enabled, the
45If one of the optical conductors is bad (as shown in the diagram box below), the converter with LLR function will return a no-link condition to its
Commenti su questo manuale